Hello all,
I have a GiEX GX02 valve that is set up with Z2M (I do not have a hub). When I paired it initially, is worked fine and I was able to control it and recieve status. The signal is very good since my repeater (light switch) is located on the other side of the wall. I used it multiple times during the day and had no trouble controlling it.
However, after a long period of no use, I am no longer to comand the valve vis Z2M. While I can’t control it, I still get status back from the valve. For example, If I manually open the valve by pressing the button on the valve, it will open and I get the correct status in Home Assistant.
This has happened a few times already and it is a consistent problem. I remery it by repairing but the problem comes back.
Has anybody experienced this problem?
Any suggestions?
Thanks.
Here’s some info from Z2M:
Availability, Online
Device type, EndDevice
Zigbee Model, TS0601
Zigbee Manufacturer, _TZE204_7ytb3h8u
Description, Water valve
Support status, Supported
IEEE Address, 0xa4c13859760e9760
Network address, 0x34A2 / 13474
Manufacturer, [GiEX]
Model, [GX02]
Power, Battery 100%
Interview completed, True
1 post - 1 participant