i have a original remote that works fine. its yooda blinds, i already connected the rfxcom to wifi after flashing it, and in rfxmngr for windows i see that the device is sniffing out the remote. i see commands such as stop, open, close when i press them on the original remote.
However, i’s unable to find out how to make the rfxcom mimic that remote, or, as the manual states, add it as new remote. when i press the p2 (programming) key once or twice on the back, i do hear and see the blinds go up and down, which should be a indication they are ready to pair. then i send the confirm in rfxmngr, while blinds t6 is selected. but after that i cannot send any other command. the blinds are not responding to the commands.
Then, in home assistant i also played around already and see i need to select a protocol. i only see blindst0. i suppose the subtypes are inclusive or something? how would we go about adding a device here? i have 4 blinds but one as group would also be fine. (the original remote can do all blinds in one command)
thanks!
1 post - 1 participant