Hello Everybody!
this is my first post in this community as i’m thinking about switching my smart home from openhab to home assistant.
(is there a section where i should present myself?)
obviously on my first day i’m already having some problems, but especially this one is not related home assistant but to tasmota (i thing?):
i got a “Zigbee Bridge pro” and tried to tasmotize/configure it according to these to tutorials:
so here’s what i did:
- tasmota web installer with Tasmota32 Sonoff-ZigbeeBridgePro
- auto config to Sonoff ZBPro TCP
- applied template from blakadder Templates (can’t insert more than 2 links) under Configuration > Configure Other
- flashed coordinator firmware according to notenoughtech . com
up until here everything worked out as expected…
then i tried to start up port 8888:
16:03:28.756 CMD: TCPStart 8888
16:03:28.760 RSL: RESULT = {"Command":"Unknown","Input":"TCPSTART 8888"}
i’ve tried to change the order for the steps above but in the end i always get this error…
don’t know if this helps, but according to the webinterace i’m running:
[Tasmota 14.6.0 (release-zbbrdgpro)](https://github.com/arendst/Tasmota)
any ideas where i’m going wrong?
best regards
Peter
1 post - 1 participant