Hi,
I stried to put my new Shelly 1PM mini Gen4 into Zigbee mode today, without any success. According to the manual, one should “push the reset button 5 times”, but that doesn’t seem to work. This is what I tried:
- Pushing the reset button 5 times. Tried various speeds.
- Pushing the reset button 3 times after I pushed it 5 times. (Since the manual says to do so if the device isn’t discovered.)
- I tried the above both with the Matter feature enabled and disabled.
- Updated the firmware to
1.6.0 beta 2, and retried the above. - Performed a factory reset (keep reset button pressed for 10 seconds) and retried the above.
- I used the diagnostics console of the Shelly web interface and was able to confirm that the button pressed do get registered by the device.
Does anyone else managed to get the device in Zigbee mode?
1 post - 1 participant