Need some configuration help. My electric company, AEP, lost funding for their energy program which made my energy bridge a brick and my smart Powerley thermostat a simple wall thermostat. It supports ZWave so I factory reset the thermostat and connected to HA using a Zooz USB Zwave stick. It detected it fine and I can see the current temp, humidity and even set the mode and fan speed. For some reason though I cannot set the temperature. Below is the configuration I see and a screenshot of the UI. Any help is much appreciated.
hvac_modes:
- ‘off’
- cool
- heat
min_temp: 45
max_temp: 95
fan_modes: - On Low
- Auto Low
current_temperature: 72
temperature: null
fan_mode: Auto Low
hvac_action: idle
node_id: 5
value_index: 0
value_instance: 1
value_id: ‘72057594127056900’
fan_action: Idle
friendly_name: Powerley Thermostat
supported_features: 9
1 post - 1 participant