Using node group associations to control multiple Honeywell switches

@Bill_W wrote:

I have several Honeywell z-wave dimmers and would like to control multiple lights from a single switch.

I’ve been semi-successful using the Node group associations section of the z-wave configuration UI. Using Basic - Double Tap and adding multiple nodes to the group I can double tap and turn all the lights on/off in the group except for the node the action is set on.

For example:

I’m setting the Node Group association on the Living Room Node: 7

These are the nodes in the group:
Kitchen Cans (Node: 10 Complete)
Kitchen Island (Node: 9 Complete)
Kitchen Table (Node: 8 Complete)
Living Room (Node: 7 Complete)

When I double tap Node 7 then Nodes 8, 9 and 10 respond as I expect but Node 7 doesn’t do anything. So to turn all 4 sets of lights on/off I have to single tap the switch, wait for the living room light to come on and then double tap it for the rest.

What am I doing wrong? Is there a better way to go about this functionality?! Thanks in advance.

image|471x500

Posts: 1

Participants: 1

Read full topic