I’m still relatively new to Home Assistant and wanted to set up some logic for my humidifier controller. I had previously coded up a 8266 with all the Logic and had my Nest calls in there but now that everything has switched over to Google I was looking to switch things up and rely more on Home Assistant. I have my google integrations set up so I’m getting all the data I need and I’m using ESPHome to create the actual switch on the 8266 but I’m lost figuring out the best way to set up the logic. Ideally what’d I’d like to do is set a target and max humidity based on the outside temperature, then filter through my 3 thermostats and test 1) if they are set to heat or Heat/cool (if not I don’t want them included) 2) test if the current humidity is below the target or above the max - if any are < target and None > max then turn on the humidifier else turn off humidifier. The switch itself is hardwired to the heat wire on the furnace so it only runs if there’s actual heat being used.
I’m not sure how to best structure the automations vs scripts and where to house the different components of the logic. Thoughts/advice/obvious documentation i missed? Thanks in advance
1 post - 1 participant