Zooz 4-in-1 Sensor parameter Setting

@Grandfx wrote:

Has anyone had any luck resetting the parameters of a Zooz 4-in1 Sensor? I am trying to turn off the LED Light from flashing. I have little experience in this, so assume the worst in what I might be doing wrong.

Under Development Tools I have selected the following service:
zwave.set_config_parameter

I have input the following JSON text:

{
"node_id": 4,
"parameter": 7,
"value": 1
}

I have called the service both before and after waking up the Zooz using a paperclip. I don’t seem to get any response that it was received the service call when I look at the OZW Log.

Link to Device Manual

I’m not sure what I am doing wrong??

Posts: 2

Participants: 2

Read full topic