Z-Wave Thermostat Entities

@Tim1 wrote:

I have been using a GoControl Z-Wave Plus thermostat (GC-TBZ48L) for some time now and am happy with it. The only downside has been that 2 climate entities are created (one for heat, one for cool). This has been normal and expected behavior.

With the release of Home Assistant 0.103 a fix was included for this (https://github.com/home-assistant/home-assistant/pull/27040) which should instead create a single entity as long as COMMAND_CLASS_THERMOSTAT_MODE is supported by the Z-Wave thermostat. I updated but still had 2 entities (I assumed this to be normal, as perhaps the Z-Wave device needed to be removed/added to be detected with the new update). I removed the thermostat via the Z-Wave control panel, verified it was gone, restarted Home Assistant, added the thermostat and then found that 2 entities were still created (one for heat and one for cool).

My thermostat seems to support the appropriate command class: https://products.z-wavealliance.org/products/2370/classes

Additionally when adding the thermostat I get the following line in the OZW Log:

Info, Node015, ZWave+ Info Received from Node 15
#and after other command classes listed
Info, Node015,     COMMAND_CLASS_THERMOSTAT_MODE

So it seems OZW does see the command class Home Assistant needs based on this new update.

Anyone having any success with the new update combining their Z-Wave thermostat entities?

Posts: 4

Participants: 2

Read full topic