Nodes working, but not showing up in config?

@eeze2 wrote:

Not sure what happened, but in the z-wave configuraiton, only 3 of my nodes are listed, yet they work on the main lovelave page (open/close door sensor)

Prior to installing the z-wave graph I noticed this. Installed the z-wave graph anyways (having just tested an open/close sensor) and the graph shows only a few sesnsors despite there being 20 of them

Image may be NSFW.
Clik here to view.

image703×318 25.1 KB

Image may be NSFW.
Clik here to view.

image1288×586 36.4 KB

Posts: 2

Participants: 1

Read full topic