@ouscotty wrote:
I have the following Aeotec light bulb.
My mother was watching the kiddos and slept on the couch in the living room and just turned this lamp off. The node was stuck in a Dead (Complete) mode. I tried healing it, refreshing it and there’s been some changes such as Dead (CacheLoad) and then trying to heal it and it would be in Initializing (Probe).
I’ve tried full on removing the node and then performing the unpairing instructions listed above in the link which is just turning the bulb off and on in succession 3 times. It doesn’t actually get removed.
The bulb acts like it’s some unholy purgatory, neither connected, nor can it be reset. I’m at a loss. Any ideas?
Posts: 1
Participants: 1