@Jonathancc wrote:
Hi all,
I recently installed a Sonoff Mini thinking it was the solution for wanting a physical switch to control my existing yeelight smart bulb setup. However I’m now experiencing the situation where the Sonoff will cut power to the bulb rendering it unavailable.
Ideally I would like to retain colour/voice control etc for the bulb and be able to use the physical switch in my wall when desired. Is there a way to configure the Sonoff Mini to only send On/Off signals to the bulb when the physical switch is toggled and have the actual power cut be limited to a specific command through HA?
If the Sonoff Mini was infact the wrong way to go about this could anybody recommend a better route?
Thanks in advance
Posts: 4
Participants: 2