Using 433mhz sender and receiver

@Kiki51 wrote:

Hi.
I have a fresh installation of home assistant running on a Raspbian image.

It’s installed on my rip 3.
It’s working well. I have follow the installation guide on the web site using the virtual environment but
I have an issue to use my remote and my plug 433mhz.
In a terminal I can send and receive code. It’s ok.
I use rfsniffer and codesend command included in rpi_utils tools.

In my configuration.yaml I have added those lines :

switch:
platform: rpi_rf
gpio: 17
switches:
pluga:
code_on: 16762196
code_off: 16762193

Pluga appears on my homepage of home assistant but when i use it my plug don’t switch off/on.
It’s the same GPIO port and the same code as the terminal command line I have use just before.
If anyone can help me!
Thanks a lot and sorry for my English.
Eric

Posts: 6

Participants: 3

Read full topic