Harmony Hub and Burned Motor!

@chrisjcbt wrote:

Hi folks,

I have a couple of Logitech Harmony Hubs, both with XMPP enabled for Home Assistant integration. configuration.yaml is below:

remote:
  - platform: harmony
    name: Lounge
    host: 192.168.10.96

  - platform: harmony
    name: Kitchen
    host: 192.168.10.97

I run a unifi network, and have given the hubs static IPs, both hubs have a very strong wifi signal. The lounge hub has an automation attached to it. When the Hub is turned On, then a Fibaro Roller Shutter 3 is triggered. Along with the reverse being true when the hub is switched Off. The automation is in NodeRed, and the automation is set to only trigger once on State Change.

A couple of weeks back the motor that the Fibaro Roller Shutter 3 controls burnt out. I could hear the motor being repeatedly triggered. The whole setup has been installed for around 5 months, and I hadn’t seen/heard this before.

I was about to replace the motor when I checked the Logbook for the setup in the lounge. If you see the attached screenshot, the Harmony Hub is constantly flipping between “unavailable” and “off”. This is what is causing the automation to trigger, and ultimately why I think the motor burnt out. If I replace the motor now, this is going to happen again.

Screenshot 2020-02-14 at 3.10.49 pm742×715 60.7 KB

Is anyone else seeing this in their Logbooks for their HarmonyHubs - and if so - any alternative integration recommendations for the harmony platform?

Thanks,
Chris

Posts: 1

Participants: 1

Read full topic