Ffmpeg_noise sensor "detected" on switching it on

@Sparkz0629 wrote:

Hey,

So i followed the walkthrough to build a smart baby monitor using ffmpeg_noise (LINK), but running into some weirdness.

When I start the ffmpeg_noise sensor it goes from “Unavailable” to “Clear” as expected, and then immediately goes to a state of “Detected”.
After the configured “reset” time it moves to “Clear” as expected and works 100% as expected thereafter.

I cannot figure out why it has a false alert at the beginning, any advise?

Posts: 1

Participants: 1

Read full topic