@fribse wrote:
I can’t figure out if the aqara cube via deconz is working yet or not, reading the posts in the forum.
I have it configured via deConz and if I monitor deconz_event I can see the events happening.
I can get a reaction on the ‘rotation’ by using device automations. But I can’t seem to get a reaction on the other motions.
I can see all the ‘go from 1 to 2’ etc. events in the automations setup for the device, but I don’t see any reaction when I try to set up automations using that.
Posts: 1
Participants: 1