@tanuva wrote:
G’day!
I have just over ten devices in my Z-Wave network, a few of them dead duplicates. To remove the dead and configure others I need to select them in the node list on HA’s Z-Wave Network Management page. (Right?) However, only five* devices are shown in that list.
The Z-Wave controller (RaZberry) is always listed, as well as node 4 (Fibaro Multi Sensor) and often the most recently added device.
What can I do to make all Z-Wave nodes selectable?
Setup
- HA 0.106.5 in Python 3.7 venv as another user
- Raspberry Pi 3 (Arch Linux)
- RaZberry Z-Wave controller
Prior work
- Z-wave devices appear in History, but not in Z-wave node list
- I already tried running a network heal, unfortunately didn’t help. All my devices are usable (except the dead ones, of course). They just don’t show up in the node list.
- Zwave Node List not fully displayed
- Same problem but apparently outdated. The Lovelace node list isn’t scrollable.
* Not entirely sure if I haven’t seen six at some point, never the complete list though.
Posts: 1
Participants: 1