I have Louvolite roller blinds, identified in HA as RollerTrol 002a6n:n (n is different for each blind).
I am controlling them from HA via an RFXtrx433E RF bridge.
The blinds respond to the three commands showing in HA dashboard (namely - UP, DOWN, STOP).
The blinds do NOT respond correctly to the the STOP command (the “My” button) when they are not moving - the correct response is to move to a pre-set position.
They do respond by moving a few centimetres at each press of the STOP command.
I have tried using the service ‘cover.set_cover_position’ - no response from blinds.
I thought the blinds responded to the logic - “if moving, then stop OR if not moving, go to set position”. This is how it works when using the manual remote control…
Can anyone shed any light on what is going on?
Many thanks.
1 post - 1 participant