@Amardeep wrote:
Hi all,
This is my first post, been started into moving from SmartThings to Home Assistant (hassio on RPi 3B+) for about a year but only just got serious recently. I’ve finally got some TRVs on my radiators. These are Eurotronic Spirit Z-Wave Plus devices, paired to my Aeotec Z Stick.
Each TRV reports the following entities:
- alarm type
- alarm level
- battery level
- power management
- source node ID
- system
- temperature (measured room temperature)
- z-wave status
- mode - "Heat " or “Off”
The TRV’s setpoint is not reported into an entity. I want to read every TRV’s setpoint into it’s own entity so that I can compare each TRV’s setpoint to it’s room temperature. This way, I can ascertain whether or not each radiator has a demand for heat. I then intended to create an automation to turn off the boiler (currently controlled by Hive, which I intend to replace with a Z-Wave controller) when there is no demand from any of the radiators.
I’ve been researching for days but I cannot find a way to read the setpoint for each TRV into an entity. The Climate cards display setpoints, does anyone know of a way I can pull these?
Any help would be very much appreciated!
Posts: 1
Participants: 1