So I’ve been migrating from Smartthings to HA, so far so good, up to the point I started trying to migrate zwave devices (locks and switches)
I have the nortek zigbee/zwave stick, and I installed zwave JS to MQTT, and I’m having a hard time adding devices.
So far I’ve tried with three, a outdoor plug, a yale lock, and a jasco switch. The lock will add, and immediately become unavailable, I’ve not been able to operate it at all. The out door plug adds, but it forever hangs in “interviewing device” and its listed, but with no options. Finally, the jasco switch, that one wont even add.
I’m running HA on a raspberry pi 4 which is located right next to the smartthigns hub, so range shouldnt be the issue. All of the mentioned devices add just fine to smartrthings.
I ordered a zoos zwave stick to rule out hardware issues, also, if all else fails, I “could” keep smartthings exclusively to act as a zwave bridge and do all my automations in HA, but that would defeat half the reason of moving to HA. Any help is appreciated.
2 posts - 2 participants