Hi there! I am moving my zwave devices from a Veraplus to HA z-wave js. I started with the Zooz ZST10-700 USB controller, than changed to the Aeotec Z-Stick 7 USB controller.
I started with a small number of zwave devices so I decided to just start over from scratch. I excluded (unpair) each device from the Zooz controller then uninstalled and re-installed z-wave js add-on (and integration) after switching to the Aeotec Z-Stick 7. The zwave devices are operating as expected after switching controllers.
However, the device info for the controller still says ZST10-700 by Silicon Labs. I uninstalled zwave js and re-installed again and no change to the label.
Anyone know if that will cause an issue? I don’t know if there are specific configuration settings and/or commands that zwave js uses based on the controller name?
Below is the device file for the Aeotec Z-Stick 7:
// Note: This device file is shared by multiple manufacturers
{
"manufacturer": "Silicon Labs",
"manufacturerId": "0x0000",
"label": "ZST10-700",
"description": "700 Series-based Controller",
"devices": [
{
"productType": "0x0004",
"productId": "0x0004"
}
],
"firmwareVersion": {
"min": "0.0",
"max": "255.255"
}
}
type or paste code here
2 posts - 2 participants