I’m in the process of moving from SmartThings to Home Assistant. I have added one of the switches and can control it just fine from home assistant when local control is enabled. When I enable to scene control and disable local control is where I run into problems. I’ve done some searching and downloaded a couple of different blueprints however nothing happens when using the light switch. I can see that the automations trigger based on their last run time but the lights never turn on/off. While the switch is in scene mode I’m able to control the lights via all 3 apps (Hue, ST, HA). I’ve even tried controlling some other z-wave devices and get the same result.
So I’m wondering what I am missing. With ST I downloaded their helper and in automations I can select tap up x1-5 , and tap down x1-5. Without using one of the blueprints I found I cannot find where I would select those options in the default ‘new automation’ wizard within HA. That or it’s just beyond my knowledge of HA configuration. I’m comfortable editing/reading yaml files but trying to decipher why the blueprint/automation yamls don’t work for my switch is a bit beyond me.
I hadn’t been able to find a blueprint specific to ZEN76 switches but also wouldn’t expect that I’d need one specific to that switch but one for Zooz in general. I did find a couple of blueprints that were specific to other Zooz switches (27, 71) and was able to modify those to not be specific to those switches but all result in the same ending, nothing I do controls the light.
My HA setup:
raspberry pi 4
HAOS - 7.6
HA - 2022.4.7
Zooz ZST10 700 usb controller
Z-Wave JS - 0.1.57
1 post - 1 participant
