Quantcast
Channel: Configuration - Home Assistant Community
Viewing all articles
Browse latest Browse all 103381

Reconfiguring ZWaveJS2MQTT to use MQTT after console only install

$
0
0

Hello,

I’m currently using Home Assistant Supervised, with ZWaveJS2MQTT installed in console only mode (no MQTT) as follows:
image

I have learned that the Scenes feature of ZWaveJS2MQTT will not work inside HA unless MQTT support is enabled as it does not do its magic over websockets, AND I have a bank of 6 blinds that stall and stutter when in motion unless I use a ZWave scene or multicast instruction to fire them all at once. So I need to enable MQTT support for this function.

I have the Mosquito MQTT broker installed and running - I added it after I implemented ZWaveJS2mqtt as it was needed for some of my other integrations.

Here’s the issue:
If I’m not mistaken, turning on that checkbox may cause HA to re-detect / duplicate all of these devices. There are nearly 100 devices on my ZWave network, so that would obviously be ‘difficult.’

Does anyone have a known good process for re-enabling MQTT In ZwaveJS2mqtt without causing a device duplication storm - else am I concerned for no reason?

1 post - 1 participant

Read full topic


Viewing all articles
Browse latest Browse all 103381

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>