Switch command_line curl with parameters

@snatch7 wrote:

Hi, i have a problem with switch and command_line with some parameters.
If i launch switch turn on and try to read a value from a sensor my command throw an exception.
My actual configuration is

switch:
  - platform: command_line
    switches:
      ipcam_motion_switch:
        command_on: 'curl -k "http://admin:pwd@192.168.x.xx/cgi-bin/hi3510/param.cgi?cmd=setmdattr&-enable=1&-name=1&-x=0&-y=276&-w=1280&-h=444&-s={{ states.input_number.motion_sensibility.state }}"'
        command_off: some value
        command_state: some value
        value_template: '{{ value == "1" }}' 

i try all combinations with and without single / double apex…

if i put the same command in a shell_command it works:

shell_command:
  motion_ipcam_on: "curl -k http://admin:pwd@192.168.x.xx/cgi-bin/hi3510/param.cgi?cmd=setmdattr&-enable=1&-name=1&-x=0&-y=276&-w=1280&-h=444&-s={{ states.input_number.motion_sensibility.state }}"

can you help me please?
thanks

Posts: 2

Participants: 2

Read full topic