Setup Home Assistant 0.108.1

@amurka wrote:

Hello!
I have a Raspberry pi 3b+ and a HomeAssistant 0.92 was installed that worked for about a year. Unfortunately, my SD card failed and I began to reinstall the system version 0.108.1.
I ran into a number of problems:

1. I can’t connect Yeelight celling lamp 650 to the color bulb. Previously, these lamps were detected automatically. Writing to the config file also does not help to determine them.

in file configuration.yaml  :
light: !include light.yaml
sensor: !include sensors.yaml

in file light.yaml:
- platform: yeelight
    devices:
      192.168.1.220:
        name: Yeelight_Ceiling_650
        model: ceiling4    
        transition: 1000
        use_music_mode: True
        save_on_change: True

2. I can’t adjust the display of the battery level in the xiaomi sensors. Earlier, I used the following code but in the new version get an error

in file sensor.yaml:

#sensor:
  - platform: attributes
    friendly_name: "Batteries"
    attribute: battery_level
    unit_of_measurement: "%"
    entities:
    - binary_sensor.wall_switch_both_158d0xxxxxxx
    - binary_sensor.cube_158dxxxxxxxx

3.I made several rooms on the main tab: corridor, study, nursery, bedroom, bathroom, living room. After I began to consistently fill these tabs with devices. I was unpleasantly surprised when I reached 4 tabs, because I saw a copy of tab 2 in it. I looked at tab 5 and saw a copy of tab 3 in it. When I try to delete tab 5, I am asked to delete tab 3. If I delete the contents of tab 5 then the contents of tab 3 are also deleted.

In the old version, there was a ui-lovelace.yaml file where you could manually edit the tabs and their contents. In the new version I did not find this. Is this feature removed?

Help me to understand. The system does not work and I do not know what to do.

Posts: 3

Participants: 3

Read full topic