Change entity state through automation?

@TheHoff wrote:

Hi all
I’ll get straight to the point. I have a Z-wave sensor, a rain gauge, that isn’t returning to zero after the rain has stopped, or ever for that matter. Only way I see it is to manually set the entity state using the Developer Tools. I have a separate thread going for this Popp Z-rain not returning to zero
My idea of mitigating the problem is by setting up an automation that would trigger if the gauge hasn’t changed to a while. That part is easily researched but not the action part. I cannot figure out how to set the state.
Any input would be appreciated.

Regards
Fredrik

Posts: 1

Participants: 1

Read full topic