No deconz (dresden usb stick) gateway

@danielgroenbek wrote:

Hi

I have moved from Pi3+ to a fresh HA install on Pi4, and in this process removed the Deconz integration on the Pi3 and moved the Conbee USB stick to the new Pi4. When installing this the first time I initially got the gateway up on the screen, but i could not complete the API integration to HA. I uninstalled, and rebooted, and then installed Deconz again. I’ve done this over an over, but the gateway (in the GUI) is gone when I navigate to the Gateway page (see image below).

Yes - i can access the GUI of Deconz but I dont see the gateway. I have tried changing the device without luck ("/dev/ttyUSB0", “/dev/ttyAMA0” and “/dev/ttyACM0”), and don’t seam to find any direction in the logs.

I didn’t add to the config.txt in my first installation, and therefore hasn’t done that on this one either
enable_uart=1
dtoverlay=pi3-miniuart-bt

image1312×844 15.1 KB

Log: https://pastebin.pl/view/68295465

Do you have any good tips?

Posts: 1

Participants: 1

Read full topic