I have a number of zwave devices that I am not able to poll. It seems to be mainly older devices and it will cost me a lot to replace them. I need to monitor what has been turned on and to automatically turn of after a specific time or after a time + a event. It is mainly Duewi switches, motor control and dimmers… When they are operated from SW the poll works fine but when they are operated manually the POLL does not work…
I have searched the forum without finding a solution but it seems that older devices might have problems with polling… This is very strange as a important part of a automation is to be able to know the state status. Especially so following manual operation…
Anu one who has ideas or work around etc…??
2 posts - 2 participants