Zigbee LED Controller

Hi Guys.

So i purchased a TuYa LED Zigbee controller but having some issues with it. I have it connected to HA via Zigbee2MQTT and can turn it on and off with no problems.

This is the controller.

Now i have these four wires from the LED strip. Red , Green White and Blue.

Now looking at the LED Controller i would have assumed Blue to B , Red to R and Green to G. It does not seem to matter where i put the White in either of the three V+ ports.

The issue is in HA i see the colour spectrum but no matter what colour i select its never the colour of the LED lights. What am i doing wrong here?

2 posts - 2 participants

Read full topic