Migrating to SkyConnection impossible due to USB port error

Hello,

after the new homeassistant core version was released yesterday, I tried to migrate to the new SkyConnect device by following the process like this:

Open ZHA Config

Start Radio Migration

Select to move to a new device

Yes, I would like to proceed

Remove old device (in my case Conbee)

Choose serial port of Skyconnect (plugged into homeassistant blue)

Select Radio Type

Select Serial interface (ttyUSB1 is correct, so I left it like it is)

Then the error occurs

Any ideas what the problem could be? Thx. Ike.

1 post - 1 participant

Read full topic