Hi All,
I am having trouble finding the root cause to an issue with my Thermostat.
I am using the Scheduler Integration to set the target temperature of my thermostat. Most of the time this works without issue.
However, on some occasions, the target temperature will reset to the previous temperature a few seconds after being set by the Scheduler.
Here is what I’m seeing in the logbook:
At 6AM, the scheduler is triggered
At 06:00:02 the scheduler sets the climate target temp to 20
At 06:00:07 something sets the climate target temp to 16 (the previous value).
I’m having trouble determining what is actually is setting the temperature to 16. I have tried two different thermostat hardware, but the issue happens with both. It is intermittent and somewhat rare. There isn’t any errors or warnings shown in the log (default setup).
I’ve scoured what documentation I could find to no avail and my searching on the issue doesnt seem to hit the right keywords. Any advice on where to start investigating the issue would be hugely appreciated!!
e
1 post - 1 participant