@mcooprid wrote:
I just started using Home Assistant and am by no means a programmer. I have been setting everything up in Home Assistant, but programming my automation in Node Red. Nest did away with their integration so I installed BadNest. It is connected and I was able to add the thermostat card to my UI. I can use the card to control my thermostat and everything responds correctly. I want to set schedules and adjust the setpoints but I can’t figure out how to pull the current values or set values from node red. (or HA for that matter, but I would like to keep the automations in Node Red)
For example I want to be able to set the target_temp_high to a certain number. I know this is under the attributes but for the life of me can not figure out how to push the value to the thermostat. I do not know how to use the attributes.
I was able to change the target_temp_high from 70 to 71 with the Home Assistant UI. Once I figure this out I should be able to get the rest of my automation going.
Posts: 2
Participants: 2