Hello All,
So last November I purchased 3 Zoos Q Sensors along with a good amount of other devices on Black Friday sales. I’m getting to setting up these sensors now and am running into a lot of trouble. One device fails to pair. I wish I checked that during the return window but will try to RMA it. The other two are performing poorly.
From one post here I saw that the motion reporting is under motion state detection, which is disabled by default and not motion detection which is one problem solved.
I have 2 remaining problems.
The first is that when I try to change a sensor parameter I get a message saying the device is asleep; but, last check in time is only a couple minutes old. Even letting it sit overnight the device never updates.
“The parameter change has been queued, and will be updated when the device wakes up.”
My other problem is that illuminance LX after about 10 minutes of use gets stuck at a very low value. I can reset the devices and they work again for a few minutes but then fail again. Temperature, humidity and motion all update normally, just not LX.
1 post - 1 participant