Hello,
Recently I noticed that there is a leakage in my watering system because I was able to see that the pump was active way more frequently while the system did nothing, therefore trying to keep the pressure in the pipes high.
I only found this because I looked at the charts, but it would be great to have an automation that would find those short peaks and check their frequency. If the frequency is too high, there must be something wrong and I want to trigger a notification. I tried my luck with regular automation, however, did not find a way to check for a recent peak.
In general those peaks have typically a duration of about 2 seconds.
Is there an easy way to solve this problem?
1 post - 1 participant