Fibaro Flood Sensor Customization

@jriker1 wrote:

OK this may be a little out there but perhaps people already know the answer to this. I just ordered a couple Fibaro flood sensors.

Trying to do a couple things:

1. Connect a long cable to SENS1 and SENS2 inside the unit.
2. Also looking at how to wire this to power as supposedly it will act as a repeater then.

image.jpg961×939 202 KB

So the above shows SENS1 and SENS2. Apparently put a wire on these and it will trigger. What I don’t know if each SENS1 and SENS2 work independently or both need to be triggered to set off the alarm, and 2 if the built in sensors on the bottom trigger still as well, AND if in HA if you can tell which is being triggered. I’ve looked at this for the wire, but not sure based on how it reads, if it’s going to work: https://www.amazon.com/gp/product/B079YB1T8J/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&th=1

Also looking at how to wire to the wall which I assume uses +12 and Ground but can’t find anyone who has done this and how that would look. Then it would be a repeater which would be cool. Like take an old two prong cable and hook it up probably?

Thanks.

JR

Posts: 4

Participants: 2

Read full topic