Hi there,
my Wallbox does provide a sensor about the current operating state with a larger text.
Yet, I don’t know all the states that the Wallbox might send - and the tile card is not capable of displaying all the content - like you can see in the screenshot below.
Therefore, I am using the Markdown Card as of now - but I would like to get a view similar to the tile card.
I don’t know if this can be done?
Secondary, I would like to change the <ha-alert> based on the content of the sensor.
I know, I can do this with an if/else template, but is there a way to validate this just on some patterns of the whole text?
here are some examples that I have already in my history of the sensor (sorry, the sensor value is in german - I’ve tried to translate them into english below)
-
Ladevorgang wurde gestartet… (bei Problemen: Prüfe bitte zuerst in den Einstellungen ‘Ladeeinstellungen’ und ‘Konfiguration’.)
- Charging process has started… (if there are problems: please first check the settings ‘Charging settings’ and ‘Configuration’.)
-
Keine Ladung, da der Ladepunkt gesperrt ist
- No charging because the charging point is locked
-
Die Ladung kann nicht gestartet werden, da die Einschaltschwelle nicht erreicht wird
- Charging cannot be started because the switch-on threshold is not reached
-
Der Ladevorgang wird trotz fehlenden Überschusses nicht gestoppt, da in dem Fahrzeugprofil die Einstellung "Ladung aktiv halten’ aktiviert ist.
- The charging process is not stopped despite there being no surplus because the setting ‘Keep charging active’ is activated in the vehicle profile.
1 post - 1 participant