When I look at the ‘Utility Meter’ entity that was created during the energy monitoring setup, it is showing the state changes in UTC instead of my selected time zone.
In this picture, you can see the changes of the energy rate which are performed by automations I setup to select the proper energy rate(s) for the time of use plan that I’m on. For instance, it shows the automation for 6AM ran at 2 PM. This is offset by 8 hours, which is the same as my time zone. The automation actually ran at 6:00AM local time, but this display is showing it as 2:00PM which is the time it ran in UTC. This is also happening on the energy dashboard where it shows consumption as well.
Is there another time zone setting I need to apply somewhere?
2 posts - 1 participant