How to stop zwave polling

@Sfmcfar wrote:

How do I stop HA from polling my Zwave devices? My understanding is that you have to turn on polling at the device level (which I haven’t done) but I’m still seeing entries like this in my OZW log:

2019-12-21 10:40:33.134 Info, Node017, Sending (Poll) message (Callback ID=0xc7, Expected Reply=0x04) - SwitchMul
tilevelCmd_Get (Node=17): 0x01, 0x09, 0x00, 0x13, 0x11, 0x02, 0x26, 0x02, 0x25, 0xc7, 0x30
2019-12-21 10:40:33.142 Detail, Node017,   Received: 0x01, 0x04, 0x01, 0x13, 0x01, 0xe8
2019-12-21 10:40:33.142 Detail, Node017,   ZW_SEND_DATA delivered to Z-Wave stack
2019-12-21 10:40:33.162 Detail, Node017,   Received: 0x01, 0x18, 0x00, 0x13, 0xc7, 0x00, 0x00, 0x02, 0x00, 0xbc, 
0x7f, 0x7f, 0x7f, 0x7f, 0x00, 0x00, 0x03, 0x00, 0x00, 0x00, 0x00, 0x03, 0x01, 0x00, 0x00, 0x8c
2019-12-21 10:40:33.162 Detail, Node017,   ZW_SEND_DATA Request with callback ID 0xc7 received (expected 0xc7)
2019-12-21 10:40:33.162 Info, Node017, Request RTT 27 Average Request RTT 35
2019-12-21 10:40:33.162 Detail,   Expected callbackId was received
2019-12-21 10:40:33.168 Detail, Node017,   Received: 0x01, 0x0b, 0x00, 0x04, 0x00, 0x11, 0x03, 0x26, 0x03, 0x31, 
0xbc, 0x00, 0x4a
2019-12-21 10:40:33.168 Detail, 
2019-12-21 10:40:33.168 Info, Node017, Response RTT 33 Average Response RTT 49
2019-12-21 10:40:33.168 Info, Node017, Received SwitchMultiLevel report: level=49
2019-12-21 10:40:33.168 Detail, Node017, Refreshed Value: old value=49, new value=49, type=byte
2019-12-21 10:40:33.168 Detail, Node017, Changes to this value are not verified
2019-12-21 10:40:33.168 Detail, Node017,   Expected reply and command class was received
2019-12-21 10:40:33.168 Detail, Node017,   Message transaction complete
2019-12-21 10:40:33.169 Detail, 
2019-12-21 10:40:33.169 Detail, Node017, Removing current message
2019-12-21 10:40:33.169 Detail, Node017, Notification: ValueChanged

Any suggestions? Thanks.

Posts: 4

Participants: 3

Read full topic