@simulot wrote:
Hi,
I have included the thermostat and heater relay to HA, and then associated them.
I have added thermostat card to UI.
It works almost, but when changing the temperature set point using the card several times, the thermostat is set to 5°C, while the card show the set point -1.1°C.
I haven’t found yet a way to reproduce the problem intentionally.the OZW_Log.txt shows that new set point is -1.1. The thermostat keep the value 5°C.
2020-01-10 19:08:50.821 Info, Node025, Response RTT 41 Average Response RTT 44 2020-01-10 19:08:50.821 Detail, Node025, Refreshed Value: old value=18.0, new value=-1.1, type=decimal 2020-01-10 19:08:50.821 Detail, Node025, Changes to this value are not verified 2020-01-10 19:08:50.821 Info, Node025, Received thermostat setpoint report: Setpoint Heating 1 = -1.1C 2020-01-10 19:08:50.821 Detail, Node025, Expected reply and command class was received 2020-01-10 19:08:50.821 Detail, Node025, Message transaction complete 2020-01-10 19:08:50.821 Detail,May be I have missed something?
Should I add a climate component or so?
Thanks for your help.
++
.Posts: 2
Participants: 2