@brentk wrote:
Hi,
I have a number of Aeotec Dual Nano switches successfully controlling some of my lights.
A couple of these lights are actually WiFi LED bulbs (of various types) which are also connected to HA.
I would like to make it so that the switch input (toggle switch) which is wired into the Z-wave nano switch doesn’t control the power to the WiFi LED bulb - but instead have HA detect the state of the toggle switch input and then switch the bulb on or off. I can successfully make it so that the switch does not control power to the bulb by changing Parameter 122 from “Control the output load itself” to “control other nodes”. This then allows me to switch the power to the bulb from HA - thus keeping the WiFi bulb always powered and available on WiFi. The part I have not been able to do is to get the status of the toggle switch input in HA. If I can get this status I can use an automation to switch the WiFi bulb. From the various reading I have done - it seems that I can get a Z-wave device to switch another Z-wave device via group association - however I have been unable to find any way to get the toggle switch input status.Is anybody able to please assist with this configuration?
Posts: 1
Participants: 1