@ha_frw wrote:
Hi Community,
when my Tradfri light devices using zha are powered off or on, their status change is not correctly reflected to home-assistant. If I control zha devices from ha, all is good.
I also understand if there would only a delay of a a couple of seconds to a minute, but it does not change until I try to power on or off from ha, then the status is right again.
Any idea, how I can fix this? a way to manually poll status? Also the zha device management page shows the device did not send an update when powered on.
let me know how you folks fixed this.
thx
Posts: 1
Participants: 1