@mick wrote:
Hi all, hope someone can advise. I’m using HA 104.2 installed by hand on a pi 4 running Buster and its working absolutely fine.
I’m also using several remote pi’s around the house with various sensors and switches connected. I have discovered that it can take upto 15 seconds for HA to detect a change in a GPIO pin state, even on a pin on the local pi running HA. Ive used the “interval” which helps but i’ve also read its being degraded and possibly discontinued.
So I have started using mqtt and the package pi-mqtt-gpio, to get over this, which also works very well with exception to getting sensor data back to the HA machine, for some reason the client will not start claiming it cant find the sensor, i’ve tried following the examples where I can, but there are no examples of the HA end (that I could find), I have more experiments to do but If any one can help with this I would be grateful.
My last question is: is it worth installing the current version of HA? 107? Does it fix the GPIO detection delay?
Any help greatly appreciated.
Posts: 1
Participants: 1