Hey, i am quite new to all this and was happy with just showing all information about my smart home for a long time.
After getting a Bosch door sensor for free and started playing around I tried to stop heating my bathroom when the bathroom window is opened.
So I went to my automation page and created two rules.
One for window_bad_closed and one for window_bad_offen; the rule seems to work because the time for last fired changes.
On my overview cards the window status is shown correctly, so I don’t think the Bosch sensor is the problem.
This is the action part of the automation:
After searching the internet a few pages suggested one should use the “hvac_mode” so i set it to off when the window is opened and to auto when the window is closed again.
Am I missing something?
Regards
1 post - 1 participant