Dear community,
today, I installed a Velux KIG 300 via the HomeKit Controller Integration.
The installation was super easy, as HomeAssistant automatically found the Velux Gateway and proposed to install this integration.
There are now two entities per shutter. I can fully open/close the shutter via HomeAssistant Dashboard, but there is no “stop” button, as I have with my shelly 2.5.
Then I found out, there is a position slider.
Questions:
- How do I get this slider onto my dashboard?
- How do I set the position of the slider via automations?
Any help is very much appreciated!
2 posts - 1 participant