@Fronobulax wrote:
Every time the power goes out long enough for the UPS to run dry and Home Assistant to shut down the following events occur. When everything comes back up all the Aqara sensors will be missing. To bring them back I have to go to every Aqara device (1 temp/humidity, 2 motion sensors, 1 door switch) and hold the pairing button for a few seconds with ZHA in add device mode. ZHA will find them, and show the new device screen with all the old information filled in, and the sensor will be back and running fine until the next power outage.
I have tried leaving them be for a while to see if they will check in and re-add themselves, but they do not.
They are farther away than the Peanut switches that are all over the house. So I think they usually connect through the Peanut mesh.
I’ve tried getting the ZHA map to work and have had no luck (really wish ZHA Z-wave graph were either part of the integration or were in the add-on store) so I’m not sure what my mesh looks like.
I’m on the .108.3 HA
I’m using a conbee II stick.
I have forced my router to not use channel 11.
My zigbee network is mostly Peanut switches that have been upgraded to the latest firmware (so they have power monitoring).
Posts: 1
Participants: 1