@Vlayke wrote:
Hi,
First of all, I’m relatively new to the Home Assistant. But I think this behavior is at least unusual, if not buggy… Of course, I might be wrong
My config:
Raspberry Pi 3B
HassOS 3.13
Supervisor 217
AEON Labs ZW090 Z-Stick Gen 5I have a few nodes in my Z-Wave network.
Three Aeotek Multisensors, an Aeotek WallMote switch and a Fibaro CO sensor.I add these devices to the network by using the “Add Node Secure” option and they show up, get identified (statuses show as “Compete”) and all is well.
But then I start to customize the entities, under the “Integrations->Z-Wave” menu. What I want to do is, I would like to disable any entities that I don’t really need. Such as “Alarm Level”, “Alarm Type”, or “Battery Level” options (my sensor are USB powered). Effectively I only want to leave the entities that I will be using actively.
When I do this, completely unexpected thing (at least to me) happens. Any Z-Wave node that I edit in such a way, disappears from the Z-Wave network management “Nodes” drop down list. Which means that I cannot edit that node’s parameters from this point onward. Or even see its status.
The only solution I have found was to re-enable disabled entities and then reboot the Raspberry Pi (but even that took me quite a lot of time to figure out, as I was first removing and re-adding the whole Z-Wave integration).I don’t believe this is supposed to be an expected behavior. I think that the actions that I perform on the “Integrations” page should have no consequences on what I can see and do on the Z-Wave network config page. If anything, it should be the other way around.
Am I missing something?
Posts: 1
Participants: 1