@czrabode wrote:
Hello. I have a Raspberry Pi 4 with a GoControl HUSBZB-1 USB stick. I installed several Aeotec Z-Wave Water Sensors along with other Z-Wave devices. However, when I go to the Z-Wave Node Management section to check out the devices, my other devices say “complete”. However, the Aeotec Water Sensors always say “CacheLoad”.
I read a Reddit post which suggested that the z-stick should be attached to a USB extension cable to bring it further from the RPi due to interference. I did just that but I’m still seeing the permanent “CacheLoad” status. Any other suggestions?
Posts: 1
Participants: 1